Free snmp trap receiver centos 73/29/2024 ![]() ![]() ![]() For a workaround, see the Knowledge Base: How can I configure sensors using speed limits to keep the status for more than one interval? After showing a Warning status or a Down status, and if there is no warning or error message in the following scanning interval, the sensor shows an Up status again. The sensor states of this sensor persist for one scanning interval only.See section List of Placeholders for Notifications. You can use specific placeholders in email notification templates to see the messages when you receive an email notification.This sensor supports the IPv6 protocol.This makes this sensor faster than when you use source filters. Add this sensor to a specific device to directly receive all messages from this device.Add this sensor to the probe device to receive all messages of the remote probe system. ![]() This sensor only supports the User Datagram Protocol (UDP).This sensor does not support SNMP v3 traps.We recommend that you use no more than 50 sensors of this sensor type on each probe. This sensor has a very high performance impact. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |